Tralas

Mitsubishi FUSO 75C18 Comfortkabine

Hydraulic sliding platform – body type ET-V-4001

Dimensions (external): approximately 5,700 x 2,300 mm.
The technical load-bearing capacity is 4,000 kg.

- The platform has 10 recessed lashing points.
- 3 sturdy lashing rings in the area of the winch displacement.
- 1 low front guard made of steel.
- 2 galvanized wheel chocks (multi-adjustable).
- 1 drip tray. A drip tray with 2 ball valves is located under the winch carriage.
- 1 spoiler flap at the rear of the platform.
- 3 rear support rollers under the platform.
- 1 rope guide pulley (galvanized and pluggable).
- 3 pulley mounting points at the rear of the platform.
- Auxiliary and tilting frame completely hot-dip galvanized.
- The platform is completely galvanized and sealed with protective wax on the underside.
- 1 lockable control box.
- 2 additional storage boxes (steel, galvanized, powder-coated with painted lids) 1000 x 500 x 600 mm.
- Aluminum side underrun protection (closed design / painted in vehicle color).
- The rope winch can be hydraulically moved across almost the entire width of the platform.
- 1 ball head trailer hitch mounted on the winch carriage for trailer transport.
- 1 planetary gear 3.5 t hydraulic rope winch with hydraulic brake.
(The pulling force is 35 kN according to DIN / The rope winch is GS and CE certified)
- 1 manual winch release.
- The winch rope has a length of approximately 25 meters.
- Radio preparation for a 4-channel radio remote control.
- 4-channel radio remote control consisting of a receiver and a handheld transmitter.
- 1 shovel and 1 broom with holders.
- 2 "SULO" trash cans with pull-out holders.
- 1 lifting and recovery crane EUROTECHNIK (with single-stage extension).
- The technical load-bearing capacity is (extended) 2,000 kg.
Fpjdpfxozzwyne Aptol
- The two crane elements can be folded down and moved sideways.
- The lifting crane is galvanized.
- 2 hydraulic cylinders for raising and lowering the lifting crane.
- 1 cylinder for extending and retracting the boom.
- 4 locking rods (galvanized) with locking pin.
- Holder for locking rods on the control box (left) tool boxes.
- 1 ball head trailer hitch 31.0 kN (ball diameter 50 mm).
- Anti-slip coating on the platform (partial sanding).
- 1 jump start system (12 volts) with 7 meter cable (mounted at the rear right in the control box).
- Holder with pylons at the rear left next to the trash can.
- 2 work lights on the front guard (LED).
- 2 work lights at the rear of the superstructure (LED).
- 1 light bar (LED technology) with illuminated center. Width approximately 1,600 mm.

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.