Tandeminis priekaba

FLIEGL Tandem-Tiefbett-Anhänger TTS 100 5,5m

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer requirements.

Chassis: Central axle trailer, low loader
Fine-grained steel welded construction
Gear-supported front support
Telescopic rear support
2 chock blocks with holder
Fenders made of sheet steel over both wheels
with anti-splash flaps only on the last axle
Aluminum side impact protection
Front crossbar that can be inserted into the floor holes
Fgsdpfx Ajzcnugoknjc
Coupling device for central axle trailer
Drawbar with tested 40 mm towing eye
Drawbar height-adjustable via spindle, max. adjustment range 250 mm
Axles + Suspension
BPW drum brake axles
"Axle/chassis laser-aligned" – reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load compensation (linkage compensation)
Wheels and tires
235 / 75 R 17.5"
as per manufacturer's choice
Steel rims, factory silver
Braking system
2-line compressed air braking system
Spring-loaded parking brake
2 fail-safe coupling heads at the front, with connecting lines to the towing vehicle
Parking sockets for electrical wiring, ABS/EBS and air connection to the drawbar
24 Volt EBS, Electronic Braking System with EBS plug at the front, with connecting cable
Caution: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
"TPMS" tire pressure monitoring system according to ECE R 141, display via display in the towing vehicle, via EBS
Electrical system
24 Volt, multi-chamber lights in LED, yellow LED lighting on the side, license plate lighting in LED
Yellow LED lighting on the side coupled with the turn signal "flashing side lights"
2 white position lights at the front in LED
2 white/red outline lights at the rear in LED
Premium LED side marker lights, with "20 LED diodes per light"
2 x 7-pole fail-safe plugs at the front, with connecting cable
Platform TTS
low-lying steel tub, platform floor made of steel/non-slip metal plate, steel walls firmly welded to the floor
Platform length 5500 mm
Tub with "Load-Lock profile" at the front and on the side for attaching lashing straps
(8 pieces at the front, 16 pieces on each side)
2 pairs of lashing rings, 1 x at the front in the corners of the steel tub and 1 x at the rear in the floor, each 5 tons
3 pairs of additional lashing rings in the floor, each 5 tons
4 pairs of lashing rings screwed onto the side walls
Ramps
Steel ramps, 2,300 mm long, 510 mm wide, can be shifted sideways
with handrail on the ramps
covered with wood (tip area with steel/non-slip metal plate)
with gas spring for single-person operation
Rear wall / rear corner posts
Screen-printed panel, 400 mm high, pluggable, between ramps
Operating instructions
The specified total weight is technically possible, depending on the load, the total weight may not be reached while complying with the permissible axle/support and saddle loads.
Country of registration / signs
Country of registration: Germany
Type approval according to EG 2007/46
prepared for license plate holder, single-line
Contour marking with reflective strips according to ECE R 048, white on the side and red at the rear
Warning sign according to ECE - 70

Custom-made transport solution

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.