Žemagrindė platforma priekaba

MÜLLER-MITTELTAL 3-Achs Plateau, luftgefedert, hydr. Rampen

* PT 30 Profile:
* EBS (Electronic Braking System)
* Emergency release device for spring brake cylinders
* Drum brakes
* 3 x 11 t Gigant axles
* Air suspension with lifting and lowering device as well as RtR valve
* Smart-Board mounted on the trailer as an infotool (for axle load display – front and rear separate)
* Tire pressure monitoring with display option in the truck via EBS signal, no truck-side installation required
* Side underrun protection
* Swivel supports at the rear on the chassis frame
* Mechanically adjustable warning sign packages at the front and rear
* Front axle with plastic quarter mudguards and splash protection
* Rear axle with straight, galvanized steel mud flaps with splash protection
* Reflective contour tape on the sides and rear
Cpjdpfsxptn Rsx Ab Hjw
* 15-pin power connector
* LED lighting 12 / 24 V
* LED rotating beacon (removable) at the rear
* Drawbar 1,200 mm long, with 40 mm towing eye and height adjustment via traction spring & turnbuckle
* Tool box made from galvanized sheet steel approx. 650 x 300 x 600 mm, black powder-coated, mounted on the right side
* Box in the bogie for accessories with folding lid, 2 container locks permanently installed (directly after the bogie platform)
* ROBOT-welded anti-slip surface on the steel plate of the bogie platform (protruding weld beads)
* Load securing package consisting of: 2 lashing eyes (13.4 t) front left & right on the bulkhead support, 1 pair each front & rear UVV lashing rings (13.4 t), as well as 3 pairs each side UVV lashing rings (10 t), swiveling and lowerable, loadable in all directions and recessed in the outer frame, each side with 3 stanchion pockets, simultaneously with 2 t lashing capability
* 6 pairs of mechanical folding outriggers for 3 m total width (not in the rear angled section)
* Widening planks stored in the middle of the loading area
* Hydraulic one-piece access ramps approx. 3,000 x 720 mm
* Mechanically adjustable sideways
* 4-way control block for later retrofit of hydraulic ramp shifting
* Excavator arm rest above the rear axle continuously to the end cross member (total length approx. 2,100 mm)
* 2 pairs of lashing eyes LC 6400 daN in the excavator arm rest, laterally in the longitudinal frame
* 2 galvanized steps on the bogie left & right
* Profifix lashing rail in the longitudinal axis, center, in the flat area for lashing up to LC 3000 daN
* Chassis, bogie, folding outriggers, drop supports and access ramps hot-dip galvanized
* Axles, turntable, air tanks, drawbar painted in black
* Loading edge when loaded approx. 910 mm +/- 20 mm air suspension
* New vehicle with manufacturer’s warranty
* Errors and prior sale excepted
* Available from approx. week 22/2026
* Sample images

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.