Žemagrindė platforma priekaba

FLIEGL DTS 300 3-Achs Tiefl Luft Hydraul - 780

New vehicle Fliegl 3 axle low loader trailer with ramps, type DTS 300
Vehicle completely hot-dip galvanized

Total weight: 24,000kg/30,000kg
Empty weight: 6,100kg
Payload: 17,900/23,900kg
Total length: 10,890mm
Loading length: 8,670mm total, 6,500mm low bed including rear bevel / 2,170mm offset Width: 2,520mm
Loading height: 860mm
Further information

plus pre-freight / provision from storage location 26639 Wiesmoor 1,280.00 ¤/ net

Rent-purchase offer: term 48 months, down payment only VAT, residual value 40%
monthly rate: EUR 569.00

Steel Welded construction
Pivot bolster with strong ball bearing ring
Foldable rear support
Wheel chocks with holder
Aluminum side impact protection
Splash flaps at the rear over the entire width (not in conjunction with forklift bracket)
Half-shell mudguard on 1st axle with anti-spray splash flaps
Anti-spray splash flaps behind 2nd and 3rd axles
1 plastic tool box, w=600 / h=425 / d=460 mm, lockable
Extensions extendable to 3,000 mm (not in the rear bevel)
(The track width of the construction machines or vehicles to be transported must not exceed the outer frame width of 2,550 mm)
Storage compartment for wooden planks in the middle of the loading area
70 mm wooden planks for widening to 3,000 mm
Lashing eyes for low loader
1 pair of lashing cutouts in the longitudinal beam at the front on a bend, 10 tonnes each.
4 pairs of lashing holes in the outer frame of the crank, each with 5 tons (tension belt attachment)
7 pairs of lashing mushrooms, set into the outer frame at the top and side, each with 10 tons
1 x at the front on the crank
6 x in the low bed
First lashing eye 250 mm from the front and last max. 250 mm from the back, distance between the lashing eyes not greater than 1100
mm
5 pairs of ring lashing eyes set into the outer frame, each with 5 tons (can be converted to stake pockets)
2 additional pairs of folding lashing eyes, each with 10 tons
1 x on the crank (protrudes)
1 x set into the ground behind the last axle
Towbar with tested 40 mm towbar
Towbar height adjustment via spring
Axles + suspension
Drum brake axles, as selected by the manufacturer
"Laser-measured axle/chassis" Reduction in tire wear and tear Fuel consumption
Air suspension with raising and lowering valve
Wheels and tires
235 / 75 R 17.5"
at the manufacturer's discretion
Twin steel rims, factory silver
Brake system
2-line compressed air brake system
Spring-loaded parking brake
Vehicle driving stability system
Axle load detection via EBS-Canbus signal, for display on display in the driver's cab, truck must be prepared accordingly, no truck installed (no calibrated scales)
2 interchangeable coupling heads at the front, with connecting cables to the motor vehicle,
24 volt EBS, electronic braking system with EBS plug at the front, with connecting cable
Lrsdpfx Ajv D T R Ejgheu
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS! Electrics
24 volts, multi-chamber lights, yellow LED lighting on the side
2 white position lights at the front
2 white/red lane keeping lights at the rear
2 x 7-pin, interchangeable plugs at the front, with connecting cable,
1 LED rotating beacon with holder, switched via parking light (light removable)
2 pairs of warning signs with double LED lighting and extendable to 3,000 mm
Floor
Front bend with steel/checker plate covering
Storage box embedded in the crossing slope to the bend
then with approx. 70 mm softwood floor, steel/checker plate covering in the wheel arch area
Rear bev

Skelbimas verčiamas automatiškai, todėl jame gali būtų vertimo klaidų.